1.

　　Introduction

　　1.1. Introduction to the Atmel-ICE

　　Atmel-ICE is a powerful development tool for debugging and programming ARM Cortex-M based Atmel

　　SAM and Atmel AVR microcontrollers with On-Chip Debug capability.

　　It supports:

　　?

　　Programming and on-chip debugging of all Atmel AVR UC3 microcontrollers on both JTAG and

　　aWire interfaces

　　?

　　Programming and on-chip debugging of all AVR XMEGA family devices on both JTAG and PDI 2-

　　wire interfaces

　　?

　　Programming (JTAG and SPI) and debugging of all AVR 8-bit microcontrollers with OCD support on

　　both JTAG or debugWIRE interfaces

　　?

　　Programming and debugging of all Atmel SAM ARM Cortex-M based microcontrollers on both SWD

　　and JTAG interfaces

　　?

　　Programming (TPI) of all Atmel tinyAVR 8-bit microcontrollers with support for this interface

　　1.2. 阿Atmel-ICE Features

　　?

　　Fully patible with Atmel Studio

　　?

　　Supports programming and debugging of all Atmel AVR UC3 32-bit microcontrollers

　　?

　　Supports programming and debugging of all 8-bit AVR XMEGA devices

　　?

　　Supports programming and debugging of all 8-bit Atmel megaAVR® and tinyAVR devices with OCD

　　?

　　Supports programming and debugging of all SAM ARM Cortex-M based microcontrollers

　　?

　　Target operating voltage range of 1.62V to 5.5V

　　?

　　Draws less than 3mA from target VTref when using debugWIRE interface and less than 1mA for all

　　other interfaces

　　?

　　Supports JTAG clock frequencies from 32kHz to 7.5MHz

　　?

　　Supports PDI clock frequencies from 32kHz to 7.5MHz

　　?

　　Supports debugWIRE baud rates from 4kbit/s to 0.5Mbit/s

　　?

　　Supports aWire baud rates from 7.5kbit/s to 7Mbit/s

　　?

　　Supports SPI clock frequencies from 8kHz to 5MHz

　　?

　　Supports UPDI baud rates from up to 750kbit/s

　　?

　　Supports SWD clock frequencies from 32kHz to 10MHz

　　?

　　USB 2.0 high-speed host interface

　　?

　　ITM serial trace capture at up to 3MB/s

　　?

　　Supports DGI SPI and USART interfaces when not debugging or programming

　　?

　　Supports 10-pin 50-mil JTAG connector with both AVR and Cortex pinouts. The standard probe

　　cable supports AVR 6-pin ISP/PDI/TPI 100-mil headers as well as 10-pin 50-mil. An adapter is

　　available to support 6-pin 50-mil, 10-pin 100-mil, and 20-pin 100-mil headers. Several kit options

　　are available with different cabling and adapters.

　　李 进

　　深圳博瑞图电子科技有限公司

　　TEL :

　　MOB :

　　FAX :

　　ADD :深圳市福田区中航路都会轩1416

　　EMAIL :lijin810230@163.COM

　　网 址：